Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[henkx]

Hello!
Can you please tell me if there is a faq-list or step-by-step-manual for configuring amule in OS X Tiger?
This woul be quite helpful.
I got problems, especially with forwarding my netgear MR814 v2 router.

thx in advance!
henkx

P.S. I found instructions concerning Netgear routers: First, go to your router control page, locate at http://routerlogin.net/start.htm. Then, on the left side of the screen, under the Advanced group of options, click "Port Forwarding/Port Triggering." Click the "Add Custom Service" button, name it aMule1 (or whatever), set it as a TCP-only forwarding, with the starting and ending port being 4662 and the server IP address being whatever local address you're using (probably 192.168.1.2, if you're the only one connected to the router, but check), and click Apply. Repeat the process with aMule2 and aMule 3, using UDP-only ports for both and starting and ending ports of 4665 and 4672, respectively. (That is, the same starting and ending port within aMule2 and aMule3, but aMule2=4665 and aMule3=4672.) Make sure that iptables is properly set up on the machine which will run aMule (as above), and you're done.

I could not find the options TCP-only forwarding and UDP-only ports. Does anybody have asolution?

[lionel77]

Not quite sure I understand your problem correctly. I think you can just forward all three ports for both tcp and udp, you do not need to do tcp-only and upd-only forwarding, respectively.

[henkx]

Thanks Lionel!
You are right, it worked due to your advice.

Now there are problems with the serverlist, but I hope to get them solved, too.